BeeBond® Clear Acrylic Foam Mounting Tape
BeeBond® Clear is a transparent acrylic foam mounting tape designed for strong, discreet bonding where appearance matters. Its clear finish allows for a clean, nearly invisible installation—making it ideal for glass, interior décor, and modern surfaces exposed to view.
The tape’s soft, conformable foam structure helps create consistent surface contact, making it easy to apply and suitable for a wide range of everyday mounting applications.
Clear Strength, Clean Results
BeeBond® Clear delivers reliable holding performance while maintaining a low-profile, transparent appearance.
Holding Strength (Guidance Only):
When applied to clean, smooth, non-porous surfaces under ideal conditions, BeeBond® Clear can support up to approximately 0.8 lb per inch of tape in shear (load parallel to the surface).
Actual performance varies depending on surface type, preparation, load direction, temperature, and application method. Always test for your specific use before full installation.
Bond strength increases after application and reaches optimal performance over time.
Indoor & Outdoor Use
BeeBond® Clear offers good resistance to heat, UV exposure, and weather, making it suitable for both indoor and outdoor applications when used as directed.
Works Well On
-
Glass & mirrors
-
Windows and display panels
-
Acrylic & polycarbonate plastics
-
Painted smooth surfaces
Surfaces should be clean, dry, and free of dust or oils for best results.
Common Uses
-
Mounting glass décor, panels, and displays
-
Attaching hooks, organizers, and trim discreetly
-
Securing signage and nameplates on glass
-
Automotive glass and interior components
-
General home and light commercial mounting
Clean, Low-Profile Installation
-
No drilling or screws required
-
Neat, hardware-free appearance
-
Conformable foam helps compensate for minor surface irregularities
Important Use Notes
-
Not intended for structural, load-bearing, or safety-critical applications
-
Apply firm, even pressure during installation
-
Allow time after application for bond strength to build
-
Always test before full use